Controls

Product DetailsVoltage12 VDCTemperature Range-40 to 160 °FDescription The Beckett GeniSys® 7556 Oil Burner Control is a potted (for high moisture environments) 12 VDC primary safety control for oil burners used on pressure washers, road stripers, crack...

Product DetailsVoltage (v)120 VACDescription48245 E Series Oil Primary Control (Optional 15 or 45 Sec. TFI. Constant/Intermittent Duty with Smart Ignition) Direct replacement for 3-wire primary controls (ex. Honeywell R8184G).This product must be...

Product DetailsVoltage (v)120 VACDescriptionThe 5020002S is a CAD cell oil primary control designed with a 15-second trial for ignition with interrupted duty and alarm contactsInterrupted Duty Ignition Recycle on Flame FailureServiceman Reset Protection...

Product DetailsVoltage120 vMountJunction BoxTemperature Range32 to 140 °FHertz60 HzDescription 60200 Oil Primary Control (15 Pre/15 TFI/15 Post. Interrupted Duty. Alarm Contacts). 15-second, 30-second TFI.Power Input (Red/White Wire): 120 vac, 60 Hz, 9...

Product DetailsVoltage120 VACMountJunction BoxDescriptionThis product must be installed by a qualified/licensed contractor and set up with properly calibrated combustion test equipment. Failure to comply with this could result in substantial property...

Description 90000 Dual Limit Temperature Controls with Manual Reset Service Pak - Includes Control Only Bock Residential Recommended Temperature Range Service Pak - Dual limit (operating limit and manual reset high limit) temperature control for...

Product DetailsVoltage24 vColorWhiteDescriptionThe DiversiTech® TT-24 Tattle-Tale Control Monitor, 24 volt AC or DC, pack of 3 identifies open controls in seconds. A single use monitoring device for determining which, safety control has opened in...

Product DetailsZones2-3DescriptionThe NCM 300 panel provides intelligent control of Heat Pump or Conventional forced air zoning systems at a maximum of three zones using motorized dampers and practically any off-the-shelf heat/cool thermostat. With...

Product DetailsMountSurfaceDescriptionSurface Mounted Closed Wiring Base.The Fireye MicroM Flame Safeguard controls are compact, modular burner management systems designed to provide automatic ignition and continuous flame monitoring for commercial sized...

Description The Fireye BurnerLogix System is a microprocessor based burner management control system designed to provide the proper burner sequencing, ignition and flame monitoring protection on automatically ignited oil, gas and combination fuel...

Product DetailsDimensions (Dims)8 x 8 x 5 inDescriptionThe ED510 Display Module is designed to operate with the FLAME-MONITOR Burner Management Control System using the EP and EPD style (remote mount only for EPD style) programmer modules as well as the...

Description1-1/4" ED510 Display Cable with RJ45 Connector.The ED510 Display Module is designed to operate with the Flame-Monitor Burner Management Control System using the EP and EPD style programmer modules. The ED510 display is optional for EPD...